| Author |
Message |
redsuns81
Posts: 12 |
 
Fri Jul 07, 2006 2:38 am |
|
I recently flash my v3,after flash my phone is not responding but when i plug in the computer software tends to be able to connect to it but unable to flash so after much research i use the motorola repair studio and try to fix my phone using the repair mode,seriously it was a bad decision and now my phone not even able to boot into the bootloader mode and when connect to the computer it just said device not recoginize.Now when i press the on button only the keypad seems to response with the backlit other then that is totally dead,No screen no bootloader no nothing.
|
 |
Advertisement
|
|
|
|
|
mikekay10
Posts: 2959
Service Provider:
Vodafone |
Fri Jul 07, 2006 6:45 am |
|
Repair studio has screwed up your PDS if you didnot make a PDS backup of your phone (unique to a phone so nobody elses will help) you will need a smartclip to fix it. Look around the forum for a post by Old Fool and send him an email - he can help.
|
|
redsuns81
Posts: 12 |
Fri Jul 07, 2006 9:54 am |
|
thank you mikekay10,beside smart clip is there any other way i could fix this mess?
|
|
mikekay10
Posts: 2959
Service Provider:
Vodafone |
Fri Jul 07, 2006 12:33 pm |
|
Do you have a PDS backup?
|
|
redsuns81
Posts: 12 |
Fri Jul 07, 2006 9:39 pm |
|
I do have pds backup but the problem is my com doesn't recoginze the phone therefore i can't do any flashing nor restore.
|
|
mikekay10
Posts: 2959
Service Provider:
Vodafone |
Sat Jul 08, 2006 3:07 am |
|
Try a google search for mr bricks unbrick your phone guide.
|
|
chesedro
Posts: 4 |
Sat Jul 08, 2006 10:27 pm |
I am looking for any help. i will try to explain.
just bought v3 last monday and on friday the battery died ( should not be a problem) but when i went to charge it . it would not chage nor would it power up.. i press the power button and the keypad lights up for about 4 secons then turns off. then lights up again when i let go of the power button. i have read several things in forums and tried them all.. pulling battery for 20 mins. holding power for 2 or mor minuts nothing seems to work.. i have read to check to see if you can get to boot loader.. i am not sure what this proves and would like to understand better.. however i AM able to see the boot loader it shows loader 08.26 and sw version R374_G_0E.42.10R_A Battery OK ok to program connect usb data cable.
however this is as far as i get. the phone will not turn on. this phone is one week old i have not attemped any fmodding on this phone. nor have i dropped it or gotten it wet... please help.. does this sound like a hardware issue or do you think i can be revived?
thank
|
|
chesedro
Posts: 4 |
Sun Jul 09, 2006 2:10 am |
|
i think i may have fixed it so far it looks good.. i download RSD lite and a monster pack.. and flashed it and after it was done the phone came right back up . it is working .. my wife will be please.. i just hope this doesnt happen everytime the battery dies.. thanks.
|
|
chesedro
Posts: 4 |
Sun Jul 09, 2006 7:38 am |
ok i spoke to soon.. the phone does come on now. however now it will not charge  ok here is what it does
if i power it on with the wall charger it comes up with "unable to charge" on the screen.
but if i power it up then plug it in. i cant see any animation that it is charging.
i get the same results weather i use the wall charger or usb to pc charger.
it did not do this before the failure. so i asume that this may be caused by software please help.
thank again.
|
|
redsuns81
Posts: 12 |
Sun Jul 09, 2006 9:37 am |
|
Ok after some research,at least my fone respond but now in permanent boot mode.
|
