| Author |
Message |
Username
Posts: 24
Phone Model:
Nokia 6230, Motorola v220, v551
Service Provider:
Cingular |
 
Fri Dec 12, 2003 11:31 pm |
|
you have to pull off the black part of the phone on the back. Under that there are two torx screws that you have to take off. Finally, snap off the faceplate.
|
 |
Advertisement
|
|
|
|
|
gforce
Posts: 858
Phone Model:
N6600. Looking around for a cheap 6630.
Service Provider:
Orange |
Sat Dec 13, 2003 8:27 am |
|
Everyone knows how to yank the cover/faceplate off. This topic is regarding availability of faceplates for the T310.
|
|
slpavman
Posts: 1
Phone Model:
Sony T616
Service Provider:
Congular |
Thu Dec 25, 2003 3:46 pm |
Yes there are faceplates available:
http://www.discountcell.com/cellular/cericssonT310new.asp
here are instructions for the T610, that is probably the same (there are 4 T6 torx screws under the backplate not 2 ...
http://www.howardforums.com/showthread.php?s=&threadid=173273
hope that helps .... (I just have to get the damn T6 torx driver ...)
|
|
Dopest13
Posts: 1
Phone Model:
Sony Ericsson T316, T28, Nokia 3390, 3395, 5190
Service Provider:
Cingular |
Sun Feb 01, 2004 7:46 pm |
| pjsabo wrote: | | Well, they may not be official.. but they're out there.. But no one selling them seems to know how to take the phone apart. It's more than just snapping apart, there are two screws holding the front in place, that are directly underneath the black plastic/antenna on the back of the phone. If that black piece can be removed, taking the phone apart shouldn't be that hard... I just can't figure out how to get it off without breaking it. |
Okay, I'm in the busniess of selling cell phone parts/assesories, (replactment parts and cell phone mods, also assesories), I bought myself a flashing keypad for my T316 and I did what the instructions said, including taking off the two screws that are located unter the black peice above the battery, then it said to just pop off the faceplate. HAHAHAH Sounds simple, HARDLY, it took me three days, so her is how to do it...
1) Take out battery, SIM card. Use your finger nail (thumb works best  to remove the top black peice on back of phone. a.) Run nail along the crack on the top of phone with gentle pressure to the black peice forceing it upwards. Click Click, that peice is off!!!
2) There are two screws on the 2 top cornors of the phone wher you just removed the black peice, remove those.
3) LISTEN CAREFULLY!!! Take a Plastic card live a credit card and run the cornor along the crack on the side of the phone, when it gets tough, bend/tilt the card like a wedge to "pop off" the faceplate (this wil be about hwere the bule and grey meet on the fron tof the faceplate). Do it on the other side also. Continue down until you are about to the bottom and you will do the same thing again.
4) WALLA!!! FInished.
If you would like cell phone parts/mods/assesories for a cheap price, contact me at: Dopest13@yahoo.com and put the subject as "Interested in cell phone parts" this way i do not delete it thinking it is junk mail!
Good Luck, any questions, e-mail me also.
Hope this helped!!!
|
|
five_hole
Posts: 1
Phone Model:
Sony Ericsson T316
Service Provider:
T-Mobile |
Wed Oct 19, 2005 2:23 pm |
|
In case you still read this board, thanks for the excellent detailed instructions, Dopest! Worked like a charm!
|
| | |
|
|
|
|
